Cleaning And Maintenance - Domo DO9247IB Manual De Instrucciones

CLEANING AND MAINTENANCE

· To protect against electrical shock or burns, do not immerse unit, cord, or
plug in water or other liquid.
· Switch off the appliance and unplug before cleaning. Also remove all ice
cubes.
· If there is water left in the water container, gently push the container
backwards so the water can run out.
· Drain all water from the water tank through the drain hole at the bottom
of the ice cube maker. Open the drainage hole on the underside of the
appliance above a collecting container or a sink. To do this, you can slide the
appliance forward, so the front protrudes 55-60 mm over the front of the
worktop.
· Regularly clean the ice basket, the water tank, the water tray, the freeze
fingers and the ice shovel. Use a soft cloth with warm water and maybe
cleaning vinegar to clean the inside of the appliance. Rinse thoroughly before
using the appliance again.
· There is a water supply filter at the bottom of the water tank. Pull the tab to
remove it for cleaning.
· Clean the outside with a damp cloth and mild detergent if necessary.
· Do not use any chemical products or products containing acids, gasoline or oil. Do not use boiling
water.
· Replace the water in the water tank at least once a day to guarantee clean ice cubes. When not using
the appliance, always drain the water from the water tank. Always use clean water when using the ice
cube maker.
RINSE THE LINES
It is recommended that the appliance lines be rinsed once a week or if the appliance has been idle for a
long time.
1. Make sure the drainage hole on the bottom of the appliance is closed; then fill the water tank with
clean water.
2. Press the selection button until the "cleaning" indicator light flashes. Then press the on/off button.
3. The cleaning cycle starts. The lines will be rinsed for a period of 6 minutes.
4. When the cleaning cycle is finished, the appliance will stop automatically.
DESCALING
Descale the appliance regularly to avoid calcification and to maintain a well operating appliance. Use a
descaling product for for example coffee makers, or use a solution of 1/2 vinegar and 1/2 water.
1. Fill the water tank with the product/solution (do not exceed the maximum level) and switch on the
appliance. The appliance will now pump water into the water tray.
2. Wait until the water container is filled with water. Look carefully through the transparent lid; if you
can no longer see water running through the water bowl, press the on/off button. The appliance
switches off and will release the product/solution from the ice tray.
! Do not make ice cubes with the appliance if there is still descaling solution in the pipes. Exposure
of the cooling fins to a descaling product for a prolonged period could cause damage to the fins.
3. Repeat this cycle a few times with the descaling product/solution.
www.domo-elektro.be
33
DO9247IB