riptunes CDB200 Manual Del Usuario página 10

Random Mode
Press the RANDOM button in stop mode or during play. All tracks on the disc will be played in random
order selected by the CD player.
Programming the CD Player
The programming of the CD player should be done during STOP mode.
1. Press the PROGRAM button. The LED display will show ' 01 ' and flash continuously.
2. Press the Previous Song / Fast Rewind or Next Song / Fast Forward buttons to select the desired track.
3. Press the PROGRAM button again to store this track in memory. The LED will show ' 02 ' and flash
continuously.
4. Repeat steps 2 and 3 to store more tracks in memory. You can store up to 20 tracks in the memory.
5. Press the PLAY/PAUSE button to play the disc in the programmed order.
6. To stop playing, press the STOP button.
7. To cancel the programming list, press the STOP button and open the CD door or set the FUNCTION
switch to the AUX/OFF position.
Tips for Handling Compact Discs
For best results, protect CDs against scratches, soil, dust, etc. If a disc is treated with reasonable care, wiping
off the disc with a soft cloth should retain its original sound quality. Discs should be stored in their original
case during periods of non-use.
 Handle a disc only by its edges. Do not touch the surface or rainbow-colored side of the disc.
 Use a soft cloth to wipe a disc clean. Do not use benzene, thinner, or other chemical cleaners to clean
the disc as damage may result. A disc should always be wiped in a straight line from its center to its
edge. Never wipe a disc in a circular motion.
 Do not expose a disc to direct sunlight, high humidity, or high temperatures for extended periods of
time. Do not place the disc on equipment that generates high surface temperatures or store them near
heat sources.
 Dust on the pickup lens can lead to erratic operation and interruption of the sound during play. To
clean the pickup lens, open the disc compartment and blow the dust off, using a camera lens
blower(available at most camera stores).
Note: Do not touch the surface of the lens. Do not allow any liquids on the inside of the
product.
 Never use benzol, benzene, or other strong chemical cleaners, as these could damage the finish.
- 9 -