Inserting Or Changing Batteries - Steinbach 061340 Modo De Empleo

The indoor unit displays both the temperature of the location where it is set up and the
water temperature transmitted wirelessly by the outdoor unit on the display.
The indoor unit can be hung on a wall using the wall mount
set up using the support stand
The signal range between outdoor unit and indoor unit is up to 60 m (65 yds.) in an
unobstructed environment. Reinforced concrete structures or similar obstructions reduce
the signal range. Likewise, positioning the outdoor unit close to sources of electrical
interference (e.g., computer monitors, TV sets, radio equipment) should be avoided.
Correct temperature measurement takes place in the shade. Keep the
measuring devices out of the direct sunlight to prevent the measuring
results from being distorted.
Water or other liquids may cause the batteries to short-circuit in the
battery compartment.
- Make sure that neither water nor other liquids enter the battery
compartment.

Inserting or changing batteries

Outdoor unit
Change the batteries in the outdoor unit
the display.
1. Turn the solar light
2. Remove the screw
3. Open the housing by turning the battery compartment cover
The housing is open.
4. Pull the battery holder
5. Remove the old batteries.
At delivery there are no batteries in the battery compartment.
6. Insert 2 new AAA batteries.
Always exchange all batteries. Never mix batteries with different charge levels. Use
only batteries that are listed in the "Technical Data" section.
7. Push the battery holder
8. Turn the battery compartment cover
so that you can re-insert the screw
NOTICE!
14
counterclockwise to unscrew it from the outdoor unit
13
to undo the locking device (see Fig. C).
19
out of the housing (see Fig. D).
22
all the way into the housing.
22
19
.
18
as soon as the battery symbol
clockwise until it fits tightly on the housing
21
as a locking device.
or it can be
16
appears on
3
.
14
counterclockwise.
21
23