Publicidad
Idiomas disponibles
Idiomas disponibles
Ballast Assembly Replacement Instructions
Ballast assembly can be replaced without the cutting
of any wires. Use of a qualified electrician is recom-
mended.
WARNING: Turn power off at the fuse or circuit
breaker.
1. Remove plastic cover.
2. Remove bulb.
3. Remove five screws attaching reflector to fixture housing.
4. Label wires according to wiring diagram.
5. Remove wire nuts from wires. Retain wire nuts to connect re-
placement ballast assembly.
6. Remove two screws and lock washers holding ballast in place.
7. Dispose of used ballast assembly.
8. Connect the replacement ballast assembly following steps 1
through 6 in reverse order.
120V AC
Input
Photocell
Socket
Black
Ignitor
Red
Blue
Model 2LBL7
Large
Coil
Ballast
Small
Coil
Lamp
Socket
Ballast
Ballast Retention
Bracket
Lock Washer
Ballast Retention
Screw
Reflector
2
Fixture Housing
Reflector Screw (x5)
598-1319-02
Publicidad
