Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
McDONALD'S GRILL SIDE FREEZER
When the equipment is received, all items should be carefully checked against the bill of lading to
insure all crates and cartons have been received. All units should be inspected for concealed
damage by uncrating the units immediately. If any damage is found, it should be reported to the
carrier at once, and a claim should be filed with the carrier. This equipment has been inspected and
tested in the Nor-Lake Manufacturing Facility and has been crated in accordance with
transportation rules and guidelines. Manufacturer is not responsible for freight loss or damage.
Note: The freezer has been shipped with casters attached. The top of the crate should be used as
a ramp to roll the cabinet from the shipping pallet. CAUTION! Use two or more people when rolling
the cabinet down the ramp, as the unit is top heavy.
GENERAL
IMPORTANT! To avoid breakage of copper tubing during shipment, the suspension springs on the
condensing unit compressor have been tightened. Before operation, the four top mounting nuts
securing the compressor need to be loosened to allow the
compressor to float freely. This can be accomplished by using
a box end wrench, crescent wrench, vise grips, etc. A label
has been placed on the facade of the cabinet as a reminder
and should be removed after this operation is complete.
LOCATION
The refrigeration system located at the top of the cabinet
requires free air access for proper operation. Allow a
minimum four-inch clearance on the top, rear, and sides of
the cabinet facade. Metal bumpers have been installed on the
sides of the cabinet to help guide it into a confined space and
protect the hinge covers and thumb screws from being
damaged. See the picture showing the bumpers. The cabinet
should also be leveled when it is placed in its permanent
location. Refer to the table below for the physical
specifications of the unit.
Unit
Model
GSF-VT
Installation, Operation and
Maintenance Instructions
INSPECTION
INSTALLATION
Exterior Dimensions
W x D x H (w/casters)
31-5/8" x 33-7/8" x 80-1/2"
Refrigerant
Type/Amount
See Serial Tag
© 2006 Nor-Lake 11/06 115624
Publicidad
Tabla de contenido
Resumen de contenidos para Norlake McDONALD'S GSF-VT
- Página 1 McDONALD'S GRILL SIDE FREEZER Installation, Operation and Maintenance Instructions INSPECTION When the equipment is received, all items should be carefully checked against the bill of lading to insure all crates and cartons have been received. All units should be inspected for concealed damage by uncrating the units immediately.
- Página 2 ELECTRICAL Check the proposed outlet to be used to insure that the voltage, phase, and current carrying capacity of the circuit from the electrical panel correspond to the requirements of the cabinet. NEVER use an extension cord to wire any unit. All inter-wiring between the electrical panel and the unit must be done in accordance with the National Electric Code and all state and local codes.
- Página 3 The Grill Side Freezer is furnished with a removable utility shelf. The utility shelf consists of a 1/2" diameter stainless steel bar running along the front of the top refrigerated compartment and a stainless steel shelf that has two rectangular openings in it. The openings in the shelf are close to the back edge and have shelf stops on the bottom side.
-
Página 4: General Maintenance
Under range (below -40°F) = LL Sensor short or break = Er°F Replacement of digital display thermometer and its probe: Disconnect the Grill Side Freezer from its power source. If needed, move the unit to a location so that the back can be removed and the wire mesh cover on top can be flipped open. - Página 5 Any correspondence pertaining to these cabinets should be directed to the Service Department of Nor-Lake, Incorporated. Be sure to include the cabinet model number and serial number with any correspondence. 800-388-5253 Parts/Service Nor-Lake, Incorporated 800-388-5253 Parts/Service 727 Second Street 800-955-5253 Sales P.O. Box 248 715-386-2323 Hudson, Wisconsin 54016 715-386-6149 FAX Email: service@norlake.com...
-
Página 6: Possible Cause
2. Adjust temperature control - see instructions under pan area 3. Too warm 3. Adjust temperature control - see instructions under pan area Nor-Lake, Inc. • PO Box 248 • Hudson, WI 54016 • 800-388-5253 Service • service@norlake.com 715-386-2323 Sales • 715-386-6149 FAX... -
Página 7: Instrucciones Para Su Instalación, Funcionamiento Y Mantenimiento
McDONALD'S REFRIGERADOR PARA PARRILLA Instrucciones para su instalación, funcionamiento y mantenimiento INSPECCIÓN Al llegar el equipo, se debe controlar cuidadosamente todos los elementos que se consignan en el Conocimiento de embarque para constatar que se han recibido todos los cajones y cajas. Todas las unidades deben ser inspeccionadas para comprobar que no existan daños no evidentes. -
Página 8: Operación
ELÉCTRICO Compruebe la toma de corriente propuesta para ser usada, a fin de asegurarse que el voltaje, la fase y la capacidad de suministro de corriente del circuito desde el panel eléctrico, corresponde a los requerimientos del gabinete. NUNCA use un cable de extensión para conectar ninguna unidad. Toda inter-conexión entre el panel eléctrico y la unidad, debe hacerse conforme al Código eléctrico nacional y a todos los códigos estatales y locales. -
Página 9: Termómetro Solar
arriba e inserte el borde posterior del mismo sobre la parte superior de la barra de modo que el reborde del estante quede debajo de la puerta del compartimiento y los topes del estante queden detrás de la barra. Deje que baje la parte delantera del estante para que quede en su posición horizontal. -
Página 10: Maintenimiento General
en el paso 2, al nuevo sensor. Se puede lograr esto atando y/o uniendo con cinta aislante el cable viejo con el nuevo sensor. Vaya al compartimiento refrigerado correspondiente al termómetro que está siendo reemplazado. Hallará el sensor colgando detrás de una placa de protección en el ángulo posterior derecho del compartimiento. - Página 11 Incorporated (Departamento de Servicio de Nor-Lake, Incorporated). Asegúrese de incluir en cualquier correspondencia el número del modelo de gabinete y el número de serie. 715-386-2323 Repuestos/Servicio Nor-Lake, Incorporated 715-386-2323 Repuestos/Servicio 727 Second Street 715-386-2323 Ventas P.O. Box 248 Fax 715-386-6149 Hudson, Wisconsin 54016 email: service@norlake.com...
-
Página 12: Servicio De Mantenimiento Y Guía De Análisis
3. Demasiado caliente 3. Ajuste el control de temperatura -vea las instrucciones para el área de la bandeja de descarga. Nor-Lake, Inc. • PO Box 248 • Hudson, WI 54016 • 800-388-5253 Service • service@norlake.com 715-386-2323 Sales • 715-386-6149 FAX...