Troubleshooting - LOTRONIC BOOST6-PORT Manual De Instrucciones

TROUBLE-SHOOTING
In case of a problem, follow the instructions in the table below. En cas de problème, suivez les instructions dans le
tableau ci-dessous. If the problem persists, please contact your dealer.
Problem
No sound
Distorted sound
No sound from the USB/SD
The red indicator flashes although
the box is not on charge
Impossible to charge or the battery
runs low very quickly
Noise
SPECIFICATIONS
Woofer ................................................................................................................................ 6.5 inch
Tweeter ................................................................................................................................. coaxial
Woofer magnet ..................................................................................................................... 80mm
Max. power .............................................................................................................................. 50W
Frequency range............................................................................................................ 55Hz-20Khz
Battery ............................................................................................................................. 12V-2.6Ah
Adaptor input ............................................................................................... 110-240Vac / 50-60Hz
Adaptor output ............................................................................................................... 15VDC-2A
Dimensions ..................................................................................................... 33cm x 22cm x 23cm
Weight ..................................................................................................................................... 3.4kg
Imported from China by LOTRONIC SA – Av. Zénobe Gramme 9 – 1480 Saintes – Belgium
IMPORTANT NOTE: Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local authorities or your
dealer about the way to proceed.
Possible cause
1. No input source
2. Volume set to minimum
3. No USB/SD card inserted
1. Volume set too high
2. Error in the audio file
1. Incompatible file format
2. No copyright
3. Card or stick not properly inserted
Power socket has not been detected
1. The adaptor has not been plugged
in properly
2. The DC plug has not been plugged
in properly
3. The battery was not fully charged
4. The battery is faulty
1. The mic is too close to the box.
2. Mic switched on but not in use
3. Mic volume too high
4. Smartphone receives a call and is
too close to the box.
5. Other wireless devices are too
close to the box.
Solution
1. Connect an AUX source
2. Increase the volume
3. Insert a USB/SD card
1. Reduce the volume
2. Check and change the audio file
1. Format must be MP3
2. Switch the box off and on
3. Insert the USB/SD firmly
It has no incidence on the box. The
indicator is just an information.
1. Plug in the adaptor firmly
2. Plug in the DC plug firmly
3. Increase the duration of charge. It
takes about 4-8 hours
4. Replace the battery by a new one
with the same specifications as the
original one.
1. Leave at least 2m distance
between the microphone and the
box
2. Switch off the mic when not in use
3. Reduce the mic volume
4. Keep the smartphone far away
from the box during calls
5. Keep the box at distance from
other wireless devices.
2280