Shoof Tailwell Manual Del Usuario página 4

1
2
3
4
5
6
Operating Instructions
Drill Choice
The recommended power drill is a standard 14-volt battery unit with an operating speed of
up to 1,250 rpm. (Higher cutting speeds do not work better, and may damage the cutters,
and will void any warranty.) A lightweight drill is easiest to use, and is recommended. A
good quality drill battery should allow trimming of 80-100 tails per charge.
Attaching to your Drill
To attach the Tailwell™ to your drill, you must loosen the drill chuck so that the trimmer
drive shaft fits fully into the chuck, then tighten the chuck. The neck strap is designed for
the drill chuck to fit through (see photo 1). This strap gives comfortable balance for the
unit to hang from your neck, and allows work hands-free between tails.
Torque Arm
The fingers of the torque fork are designed to straddle the drill body to prevent the
Tailwell™ rotating about the drill (see photo 1).
Lubrication
Important: Before operating this machine, the cutters and gear set must be well-oiled
using the oil supplied, or ordinary engine oil.
There is an oil hole in the side of the plastic gear set cover. Squirt 3 or 4 drops into this
hole while the unit is running (photo 2), and also add 3 or 4 drops around the cutters
(photo 3 & 4). This should be repeated every 50 tails, or more frequently if the tails are
wet and dirty. An alternative method of oiling is to dip the cutter head frequently into
a small bowl of oil, but seperate frequent lubrication will still be required in the gear set.
The warranty is void if the tail trimmer has not been properly lubricated.
Safety
The inner cutter does not move, so cannot cut the animal. The outer cutter oscillates
through only 18 degrees, so is also safe. The tail is fed into the cutters, and pulled
through as required. Operate the drill at a suitable speed (up to 1,250 rpm) to ensure
clean cutting.
Cutter Adjustment
Before adjusting - clean and lubricate the cutters.
There are two cutter-adjustment screws on the back-plate of the cutter housing. These
screws have lock nuts that must be loosened a couple of turns (photo 5). The adjustment
screws are then screwed in by hand, finger tight only (photo 6). Do not tighten these
screws with an Allen key as this will cause cutter and gear failure, voiding the warranty.
The lock nuts are then tightened with a spanner. Lubricate the cutters before use.
Tips
Do not force the cutter. Let it do the work, especially if tails are heavily dagged. Let the
cutter chew slowly through badly matted hair. In worst cases, dags may have to be pulled
apart to enable the cutter to work. If cutting is not even all around, the cutter tension
screws may need adjusting.
Storage
It is imperative to carefully clean and thoroughly relubricate the gears and blade set,
prior to storage in a clean and dry environment. The blades are manufactured from high
quality tool steel but will rust and potentially seize if not stored well lubricated. To do
this correctly the blade set must be removed (following our instructions supplied) and
packed with grease between inner and outer blades, and also around the gear set. Blades
and gears should also be checked for wear at this time. Reassemble and check all body
screws for tightness.