Sea gull lighting 8538601 Instrucciones De Instalación página 2

Install the Fixture
1A
JUNCTION BOX
1
HOT WIRE
Secure the mounting plate to the junction box.
1
Connect the fixture to a suitable ground in accordance to local electrical codes.
2
Connect the white fixture wire to the neutral power line wire with a wire nut.
3
4 Connect the black fixture wire to the hot power line wire with a wire nut.
Align and place the fixture base onto the mounting plate studs and secure it with the two cap nuts.
5
Place the shade and spacer over the socket and onto the shade base, then secure them in place by screwing the collar nut
6
onto the socket. Repeat for remaining shades.
7
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
8 For wet locations, caulk around the base of the fixture with waterproof construction sealant.
MOUNTING
PLATE STUD
WHITE WIRE
NEUTRAL WIRE
1
3
4
MOUNTING
PLATE
BLACK WIRE
CAP NUT
FIXTURE BASE
5
6
7
2
8
SHADE BASE
SOCKET
SHADE
SPACER
COLLAR NUT
LAMP