iCES IFS-400 Manual Del Usuario página 3

OPERATION
CAUTION: ALWAYS USE FOOD PLATEAU SUPPORT AND FOOD PUSHER
1. Plug into AC 230V~ 50Hz outlet.
2. Place food to be sliced on the sliding feed table and press the piece holder against
thickness guide. Then pull the sliding feed table against the blade by hand.
3. The maximum size of food is:110x110x90(mm)(length x width x thick).
4. Switch on the appliance.
5. When the blade is rotating, push the sliding feed table toward blade. Move tray back
and forth steadily. Keep food gently pressed against guide for even slicer.
6. Do not operate the machine more than 5 minutes. The motor may be overheat. Turn
off switch & let it rest for at least 30 minutes to cool down the motor.
7. During slicing, if the rotational speed of blade reduces, let food unfreezes for a while,
then slice again.
8. When finishing slicing, unplug unit. For safety and blade protection when storing, turn
thickness adjusting knob to align thickness guide with blade.
CLEANING
UNPLUG SLICER FROM OUTLET
All slicing parts remove for thorough cleaning. Wash with a soft cloth or sponge and a mild
soap or a spray cleaner. Rinse and dry.
Never use steel wool or scouring powder on any part of slicer. Do not wash any part
of slicer in dishwasher.
Motor is concealed in housing. Never submerge water.
Motor never needs oiling.
.
PIECE HOLDER:
Remove the piece holder from the sliding feed table.
SLIDING FEED TABLE:
Clean the sliding feed table after removing the piece holder.
STAINLESS BLADE:
Unplug the item ,loose the left-screw as the arrow direction .Then take off the blade
carefully with hand glove. After cleaning, tighten the blade with the left-screw on the
contrary direction.
:
Note
Always align thickness guide with blade for safety and blade protection
during storage.
NONSLIP FEET:
Clean with any grease-removing cleanser, such as alcohol or window cleaner.
STORAGE
Align thickness guide with blade.
Wrap cord in storage area on bottom of slicer.
3