Publicidad
3
Push the B Pad into the bottom of the shell.
5
Slide the J Open Channels over the RECTANGU-
LAR partitions; then slide the K Closed Channels
over the triangular partitions.
K
Remove the backing material from the L Rubber
7
Feet, and place them on the printed squares; press
firmly.
3079-37: 2 of 3; 7/97
B
L
Safco Products Company, New Hope, MN 55428
4
Place the Rectangular Partitions ( C and D for
Model 3079; E , F and G for Model 3081) in order
by height. Push the Triangular Partitions ( H for
Model 3079; I for Model 3081) down into the slots
until the "locking cut" is fully seated and the
6
Place the assembled divider into the shell.
J
8
Completed Upright Roll File.
partition bottoms are even.
LOCKING CUTS
Publicidad
