Husqvarna 28008908044 Manual Del Usario página 6

6
- Mount rubber grommets 
- Position retaining bracket 
shown.
- Mount screws  with washers
- Position combination instrument support
- Mount screws  (included) and tighten to 6 Nm.
- Join and position plug-in connector
- Position the combination instrument.
Route the cable free of tension and ensure that the cable can-
not be kinked or pinched!
- Mount screws  (included) and tighten to 10 Nm.
- Position well nut  (included).
- Position fl yscreen  (included).
- Mount screws  (included) and tighten to 3 Nm.
NOTE
When mounting the screw, the well nut
the screw  at the same time so that the screw can engage the
thread. When tightening, the rubber swells up on the well nut.
on retaining bracket  (included).
on the combination instrument as
 (all included) and tighten to 2 Nm.
 (included) as shown.
 .
 must be pressed against