AMS LASER 3 LED Guia De Inicio Rapido

EN
LASER 3 LED
LASER/LED Effect
Installation
1.Please check the voltage whether is the same with the one showed on the equipment or not.
2.It must ask for the technical person and set the light safety when installation, and let the light beam at the suitable angle.
3.When install this equipment please make sure there's no flammable surfaces(decorated things, etc) within at least 2.5M
and maintain minimum distance of 0.5M from the equipment to the walls.
4.Please make sure that there's no other equipment or decorating materials obstructed the exhaust fan and the vent-pipe.
5.Products should be install immobility.
6.In case of safety, it's very important that to connect the earth with line.
Attention
1. Please do not open the button cover yourself without permission, operate it accord the user manual, call the technician
when the machine breaks down.
2. Please do not see the laser beam directly to avoid any damage.
3. Before connect or disconnect the power, please adjust the luminance of the laser diode to the least to avoid any damage
to the laser diode.
4. This unit should be keep dry, do not use in the rain and dusty environment, it can be use in the outdoor with the water-
proof cover protector.
5. Set the light immobility and try to avoid strong shake or hit.
6. Prevent dust into the equipment to avoid problems.
7. Please keep that there's no other equipment or decorating materials obstructed the exhaust fan and the vent-pipe when
the equipment was working.
8. Before connect power, check the plug is immobility or not, power line should be connect well.
9. Please do not open or close the equipment frequently that's to avoid any affect to the life span of the laser diode, and try
the best to avoid the long time working.
10. Due to the characteristic of the laser diode, after 4 hours working, it should be close at least 25 minutes until the laser
diode cooling then work again.
11. Don't touch the light or draw the power line when your hand was wet, and do not pull the electronic power line.
Rev. 16.04.01
LASER 3 LED 1