Atlantic CC06 Manual Del Producto página 4

Connecting the Light Bar
All Color Changing Colorfalls and wiring components are connected via quick-connect plug.
Color Changing Colorfalls will not operate if plugs are aligned incorrectly. The connectors are
keyed to ensure the connections line up properly. Color Changing quick-connect plugs carry
both AC and DC current to the in-line driver. Moisture entering the connections will allow the
AC and DC current to cross which can damage the lighting system.
Quick-connect plugs are gasketed for outdoor use and must be fully tightened to
prevent water infiltration. Quick-connect plugs are not waterproof and should not be
submersed. Dielectric grease is included and should be used in all connections to eliminate
water infiltration.
The transformer must be plugged into a properly grounded GFCI outlet. Please follow the
connection diagram below for proper installation.
Transformer
Multiple Colorfalls can be connected by using Atlantic Color Changing Lighting
components. For installations up to 40 watts, purchase additional Splitters (CCBSX4) and a
larger Transformer (TRANS60). (ADD STUFF ABOUT CONNECTING TO LIGHTING)
To connect multiple Colorfalls up to 120 watts, purchase an InfiColor 3 Light Wiring Kit
(CCSM30X3), Splitters (CCBSX4) and 150 Watt Transformer (TRANS150).
INFICOLOR SMART MODULE
Installation
The InfiColor Smart Module is weatherproof, but must be mounted above the ground on a
wall or post within reach of a properly grounded GFCI outlet. Do not submerse the Control
Module or expose it to heavy rainfall.
• Install the Module in a well-ventilated area to ensure that the module operates within its
specified working temperature.
• Verify that the Smart Module input voltage is 12 volt AC. We recommend that you use the
transformer provided with this unit.
• Use dielectric grease on all connections and ensure that all cable connections are secure.
• Do not connect the power before the cord connections are finished.
• Do not cut or alter any round cords. Cutting or damaging any round cord will void the warranty.
CONNECTING TO SOL COLOR CHANGING MODULES
All Atlantic Color Changing Lighting and Colorfalls is fully forward and backward compatible. The
Colorfalls includes an adapter to connect to any SOL Color Changing Control Module or connect
SOL Colorfalls to the new Smart Module. The adapter is not necessary for new installations.
Apply dielectric grease, included with the InfiColor Smart Module, to the pins of the plugs on
the Module and light cords. Line up the keys; the plugs will only fit one way. Connect the plugs
to the adapter and tighten the threaded ring. Complete the tightening process by wiggling the
connection and retightening the threaded ring 2-3 times until firmly seated.
4
Smart Module
LED Light Strip