Gabarron TGV200 Instrucciones De Instalacion Y Uso página 4

1.- IMPORTANT INFORMATION
•
Read these instructions carefully before installing or using this heater for the first time. The guarantee will not cover damage caused by
not following these instructions.
•
The instructions should be retained for future reference. This guide must be kept and given to any new owner.
•
This appliance is designed for domestic use only.
•
The use of this heater is forbidden in areas where gases, explosive or inflammable substances are present.
•
DO NOT USE THIS HEATER TO DRY CLOTHES.
•
Ensure the power supply to the socket into which the heater is plugged is in accordance with the rating label on the heater.
•
Keep the power cable away from the hot body of the heater.
•
Do not let the cable hang over the edge of a table or counter or let it come into contact with any hot surfaces.
•
Do not use the heater while sleeping. Never leave the heater unattended while it is operated.
•
The improper handling can cause injuries.
•
Always unplug the heater when moving it from one location to another.
•
Do not pull on the connection cord, but rather on the plug, to separate the appliance from the mains.
•
Do not use extension cable. This could overheat and cause fires.
•
Never touch the heater with wet or humid hands or barefoot.
•
Do not leave any object above the heater, covering the grill, or restricting the air flow.
•
The heater must be disconnected during installation and cleaning.
•
The heater should not be located in front of, or under an electrical socket.
•
The heater should be positioned so the controls cannot be used when using the shower or bath.
•
The location of the heater should not be close to curtains or other inflammable articles, and the heater must not be located immediately
below dripping clothes.
•
It is important to maintain a minimum distance of 80 cm between the heater and curtains, or any other combustible materials.
•
Never rotate the heating part of the appliance during operation. To change the tilt angle of the heating part, we advise you to wait for 15
minutes after the appliance has been switched off.
•
Avoid using the heater where there are children or disabled persons without being adequately supervised by a responsible person.
•
Never dismantle the components of the heater or replace the components with the ones that do not meet the safety requirements. If the
supply cord is damaged, it must be replaced by the manufacturer or its service agents or a similarly qualified person in order to avoid a
hazard.
•
The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance
•
The heater should be switched off and be disconnected from electric supply to avoid accidents when it is not being watched or not in
use for a long time.
•
Ensure the voltage is suitable for the heater. Refer to technical label.
•
The presence in the atmosphere of tobacco smoke or atmospheric pollution can with time discolour the heater surface.
•
Stand the appliance on a table or flat surface.
•
Do not use outdoor.
•
WARNING: In order to avoid overheating, do not cover the heater
2.- INSTALLATION
Open the box to take out the heater and all the accessories.
When you install the heater, please refer to the picture.
• Select a suitable place to install the heater, heater should be hung on the wall at least 100cm above the floor, the distance away from
two side wall should be more than 20cm.
• Drill two holes on the wall, with the distance between as 15cm and then locate the anchors in the holes. Part of the screws should left
outside the wall in order to hang the heater.
≥20cm
≥20cm
≥100cm