adm 700263 Guia De Inicio Rapido

ENGLISH
PIR is move sensor intended for a non-contact switching
on/off LED stripes and slim line LED light fixtures
mounted in aluminium tube (profiles).
Technical specifications
input voltage range
rated power
maximun load
IP protection class
Safety conditions
The manufacturer assumes no responsibility for any
damage caused by improper use of the product,
changes to its design, use of inappropriate items, or not
following these instructions.
-
The switch is designen for indoor use and has been
made for safe voltage of 12V DC.
-
The total power of connected LED lighting fixtures
cannot exceed the rated power of the switch.
-
Installation must be carried out in accordance with the
installation instructions.
-
When installing the switch cannot be connected to a
power source. In case of any doubt, consult a
specialist.
-
To clean, use only a soft, dry cloth; do not use
detergents.
-
When not using the device for a long time disconnect
the cable from the power supply system.
-
Installation should be carried out according to the scheme. Outputs from LED
and power lightning should be soldered to the switch , or in the version with
cables, connect eg with an electric block.
-
Check correctness of mounting and connections. Peel the protective foil
tapes. Install the switch at the selected place.
-
Turn on the power
-
The mounting hole for the motion sensor should be made in the plexiglass
cover with 100mm drill bit.
ATTENTION! Do not install near: air conditioners, moving objects, heat sources,
devices emitting electromagnetic radiation.
12V DC
After powering up, the sensor is armed (maximum 60 sec.), during which time the
sensor may not respond. After detecting the last movement, the detector keeps
30W
the light source on for about 2 minutes. After this time, the lighting switches off.
< 2.5A
From the moment of turning off the light source for about 5-10 seconds. the
IP20
detector does not respond to movement ( the sensor is re-armed).
The switch board has potentiometers that allow you to adjust the time (TIME) and
sensitivity (SENS) of the motion sensor. Adjustments should be made with the
power off. Maximum lighting time 4.5 minutes. Sensor range max 200 cm.
WARNING! If there is no reaction switch to touch, or continuous self-brightening,
disconnect the power supply, wait 30 seconds and reconnect the power supply.
Must not be discarded with household waste!
This product contains electrical or electronic components that should be recycled.
Leave the product for recycling at the designated station, e.g.: the local authority's
recycling station.
Installation
Instruction manual
Information on disposal of waste electrical equipment
700263
Interruptor Sensor Movimiento 30W-12V