Electric corkscrew Use instructions
Sharp parts! The product has a cutting edge that could cause
injury, it is recommended to pay close attention.
Product description Fig.A
1. Capsule cutter
2. Grip
3. Operating light
4. Operation button
5. Battery compartment
6. Spiral
Operation
Open the battery compartment placed on the rear of the grip by pressing down on the tab above the com-
partment.
Remove the cover.
Insert 4 AA batteries into the battery compartment, respecting the indicated polarity. Make sure the tape stays
under the batteries to make it easier to remove later.
Slide the two tabs of the cover over the compartment and close it.
Before using the corkscrew, remove the protective cap placed on the neck of the bottle, using the capsule cutter
supplied.
Place the capsule cutter on top of the wine bottle and turn it clockwise, cut and remove the protective cup.
Once the protective cup is removed, place the corkscrew on the top of the bottle, making sure to always keep it
as vertical as possible. If the corkscrew tilts slightly it will not be able to extract the cap correctly.
Hold the bottle firmly with one hand and the corkscrew with the other hand, press the bottom part
of the operation button . The corkscrew spiral will rotate clockwise, first by drilling the cap and then extracting it.
The corkscrew will stop as soon as the cap is removed completely.
To remove the corkscrew, press the upper part of the operation button
se, releasing the cap.
Attention: if the battery charge runs out during the extraction of the cap, do not exercise force on
the bottle cap. Simply rotate the corkscrew counter-clockwise so that it can release the cap. Then
replace the corkscrew batteries.
Cleaning
Clean the product with a slightly damp soft cloth.
Be careful not to let water or other liquids enter the product.
Technical data
Power supply 4xAA (not included)
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
. The spiral will rotate counter-clockwi-
6