Publicidad
Step 20
Unfold the BACK (H) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (H). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (H) to the top and side edges of your
å
unit. Use nineteen BLACK 9/16" LARGE HEAD
SCREWS (1S). Fasten the remaining BACK to your unit
using the NAILS (1N).
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHT (C2) and SHELVES (E2).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
BLACK 9/16" LARGE HEAD SCREW
(19 used in this step)
www.sauder.com/services
1S
These holes must line up
over the UPRIGHT (C2).
H
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the SHELVES (E2).
402905
1N
NAIL
(21 used in this step)
Page 25
Publicidad
