Specific Safety Rules - Promaker PRO-LO180 Manual Del Usuario

4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b) Do not use the power tool if
the switch does not turn it on
and off. Any power tool that cannot
be controlled with the switch is
dangerous and must be repaired.
c) Disconnect the plug from
the power source and/or the
battery pack from the power tool
before making any adjustments,
changing accessories, or storing
power tools.
Such preventive safety measures
reduce the risk of starting the power
tool accidentally.
d) Store idle power tools out of
the reach of children and do not
allow persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check
for misalignment or binding of
moving parts, breakage of parts
and any other condition that may
affect the power tool's operation.
If damaged, have the power
tool repaired before use. Many
accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier to
control.
g) Use the power tool, accessories
and tool bits, etc. in accordance
with these instructions, taking
into account
conditions and the work to be
performed. Use of the power tool
for operations different from those
intended could result in a hazardous
situation.
5) SERVICE
Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.

SPECIFIC SAFETY RULES

WARNING: ALWAYS use safety
glasses. Everyday eye glasses
are NOT safety glasses. A lso use
face or dust mask if operation is
dusty. ALWAYS WEAR CERTIFIED
SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection
(CAN/CSA Z94.3)
• ANSI S12.6 (S3.19) hearing
protection
•NIOSH/OSHA/MSHA respiratory
protection
• Sanding of lead-based paint is
the working
4