Maintenance Instructions - StarMax STFFS40-8JAF Instrucciones De Operación

GUARD & FAN BLADE ASSEMBLY
1. Take the Spinner out from the bag, then remove the plastic nut by turning it
counterclockwise.
2. Place the rear screw guard to the head unit and make sure the handle is
upward.
3. Screw on the plastic nut (clockwise) securing the fan guard on the head unit.
(Step 1, 2, 3 see Fig. 7).
4. Install the fan blade onto the motor shaft. Make sure the fan blade slot fits into
the remaining pin of the motor shaft. (Step 4, 5, see Fig. 8)
5. Attach the spinner to the motor shaft by turning it counterclockwise to secure
the fan blade.
6. Secure both guards firmly by tightening the fan guard then close with clip.
(Step 7, 8 see Fig. 9)
OPERATING INSTRUCTIONS
1. Speed control
Speed is controlled by pressing the speed control buttons.
OFF – Off, L – Low, M – Medium, H – High
2. Clutch knob
Press down this knob to oscillate the fan. To choose one direction, pull knob up
when the fan is in the desired direction.
3. Tilt adjusting
To adjust the air flow upward or downward, push the guards slightly to the
desired direction.
4. Height adjusting
Hold the extension pole, loosen the height adjustment ring and adjust the internal
pole to the desired height. (See Fig.5)

MAINTENANCE INSTRUCTIONS

The fan requires little maintenance. Do not try to fix it by yourself. Refer it to
qualified service personnel if service is needed.
1. Before cleaning and assembling, do not plug into the socket.
2. Ensure adequate air circulation to the motor. Keep vents at the rear of the
motor housing free from dust. A vacuum cleaner should not be used to clean
these vents before unplugging. Do not disassemble the fan to remove dust.
3. Please wipe the exterior parts with a soft cloth and a mild detergent. Do not
use any abrasive or solvents that could scratch the surface. Do not use any of
the following as a cleaner: gasoline or thinner.
4. Do not allow water or any other liquid into the motor housing or interior parts.
3
Screw