Warnings And Precautions - Prilux 240840 Guia De Inicio Rapido

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNINGS AND PRECAUTIONS:

• This product is suitable for use both indoors and outdoors.
This is a decorative product! It is not a toy, keep out of reach of small
children.
• Do not manipulate the product while it is working.
• Under no circumstance, should you cut, change or reduce it.
• Do not use this product in contact with water directly or with wet hands.
• Make sure that all the connections are well placed and right tight and
sealed.
• Check that all the connections are secured with its corresponding heat
shrink tube
• Protect all the cables against any possible damage.
• The lamps are not exchangable.
• Do not connect this product to another.
• If the product is defective, it must be disposed.
• Throw away properly any defective product.
• Never place or use this product close to heat sources.
• Disconnect the electrical current before installing this product.
• In case of technical questions, ask always to qualified staff.
WARNINGS - BEFORE PUTTING INTO OPERATION
• Before putting it into operation, make sure that the voltage of the grid is
compatible with that one which is indicated in the power supplier.
• Before putting the product into operation, check out that it is not dama-
ged.
ASSEMBLY INSTRUCTIONS: SAFE INSTALLATION
GENERAL
• Do not use any metal tool or material which lead to a cut in the thread.
Those might damage the product, cause short-circuits or a bad performance
of the product.
ASSEMBLY:
1
To begin with the installation of the
product, check firstly that you have
all the parts that make it up: base
and tree.
• Take into account that the useful life of the product depends considera-
bly on the way it is mounted, dismounted and deposited.
• Treat it always carefully and properly.
ASSEMBLY
• For the assembly ( ex. steel cable), use preferably UV-resistant seals or
original accessories
• Mount always this product the most stable and right possible. Do not let
this product hang freely.
• Make sure that the minimum distance of 1.5 cm between cables and
lamps is not exceeded.
• In operation, lamps and cables must not be touched, crossed or being
rolled or twisted.
ASSEMBLY INSTRUCTIONS: SAFE EXTENSION
• Do not connect between each other more products than those which
are authorised.
• Take into account the fact that the maximum quantity of products
connected which you will find on the upper chart of the package or in our
catalogue.
RECOMMENDATIONS
Reviewing all connections and splices motives and Christmas products is re-
commended before and after their operation in each campaign to prevent
condensation and expansion joints.
It is recommended NOT expose to weather the bright thread over a year to
prevent degración by ultraviolet rays.
We recommend uninstalling the product at the end of each campaign.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

240857

Tabla de contenido