Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Our Outdoor LED Flood offers many possibilities to achieve the effects which you want. It is for DJs, bands, night-
clubs and other performers who want a complete LED wash light system. Please read the manual before
operation.
A.
Specification
• Power input:
100VAC—260VAC
• Wattage:
less than 23W
• LEDs:
7*Tri-3W
• Control feature:
DMX512, M/S, and Auto running
• Size:
150 x 90 x 70 mm
• Operation mode:
IR remote
• Weight:
1.3 kgs
• IP rate:
IP66
B
Operation instructions
The mode operation instruction: this fixture can choose five modes: auto run, built-in programs, dimming mode,
slave mode, DMX control
1.
IR Remote
Sheet 1 IR remote buttons function instructions
LED function mode
IR remote buttons
Auto run
Built-in programs
Static monochrome
(built-in programs 1)
Dimming mode
Slave mode
DMX control mode
Restore factory
settings
rayTEC - English Manual
Turn off LED (Dmx mode, slave mode controlled by master), and then
BLACKOUT
press once more to recovery.
AR
Auto run (built-in programs 2-7)
Select the built-in programs
press down the SPR(LED light prompting: LED turn yellow, and then
SPR + numeric
turn off ), and then press the numeric keys (1—6) select the built-in
key
programs) specific please see sheet 3; now press "+", the built-in pro-
gram speed increase,press "-", the built-in program speed reduce
In dimming mode, press the "FL", single color strobe, and then press
the "FL" to recover dimmming mode.
FL( FLASH )
If press the "FL" is not in dimming mode, seven color stroboscopic
(built-in programs 7)
R ( G/B ) + nume-
Press down the R (G/B ), and then press the numeric keys 0—9 select
ric keys (0—9)
10 kinds of corresponding color, specific please see sheet 4
Press down the "R", select the red LED dimming, press down the "+" ,
the brightness increases, press the " –" , the brightness reduce, when
R + buttons+ (--)
reach the maximum brightness, or the smallest, then press the "+ (--)",
the red LED strobe
Press the "G", select the green LED dimming, press the "+ ", the-
brightness increases, press the " –" , the brightness reduce, when rea-
G + buttons+ (--)
ch the maximum brightness, or the smallest, and then press the + (--),
the green LED strobe
Press down the "B" select the blue LED dimming, press down the "+",
the brightness increases, press the "– ", the brightness reduce, when
B + buttons + (--)
the brightness reach the maximum,or the smallest, and then press
the "+ (--)", the blue LED strobe
SL (SLAVE)
Select the slave mode
D (DMX MOOD)
Select the DMX mode,the DMX function please see sheet 4
Set the DMX address value
Press down the "S", setting the DMX address value, LED will be
S (SET ADDR) + 3
peompted the current DMX address value, see note 1, and then press
numeric keys
3 numeric key to complete setting, LED prompt setting address, plea-
se see note 2
BLACKOUT
Press the "BLACKOUT", will turn off the light,in this state press the
+ keys 9, 8, 7
numeric keys 9, 8, 7 in turn, to restore factory settings
PAG. 2
Function
Publicidad
Tabla de contenido
