minkaAire K9110L Instrucciones De Montaje

CAUTION: Before starting installation, disconnect the power
by turning off the circuit breaker or removing the fuse at the
fuse box.
1. Loose the screws and remove the switch cup.
(Fig. 1- A&B ).
Loosen the connection plus from the switch cup and fan
if applicable .(Fig.1-A)
2. Remove and discard the center plug from the switch cup.
Attach the light kit to the switch cup by feeding the wires
and threading the light kit the through the hole of the
switch cup, secure it to the switch cup using the nut and
lock washer. Be sure it is tight enough to prevent the
light kit from vibrating loose. (Fig.1-A&B)
3. Make the wire connections as follows and secure with the
wire nuts provided:
- Connect white wire from switch cup to white wire from
light kit.
- Connect blue wire from switch cup to black wire from
light kit.
-Connect the connection plugs from the switch cup and
fan if applicable.
4. Re-attach the switch cup with light kit attached to the
motor assembly and secure with the screws previously
removed.
CAUTION: Make sure that the wires are not pinched
between the switch cup and the switch cup plate.
Note: Lamping in excess of 75 watt will disable your light kit. To
reset your light kit you must turn the power off and re-lamp
keeping the wattage under 75 watts.
6. Remove the rubber washer, metal washer, metal nut,
metal cap from the light kit. Place glass shade over the
light kit stem, secure with the rubber washer, metal
washer, metal nut, metal cap. Do not overtighten. (Fig.3)
Remark: For your convenience we have included two extra
sets of cap to help better match the finish of your fan.We
also have included 3 extra cap without hole in case you use
receiver L001047010 If the cap provided do not match your
fan finish feel free to paint them to your liking.
CAUTION: To reduce The Risk Of Fire And Electric Shock
This Light Kit Should Be Used Only With The Fan Models
Listed Below: Models: CF554A-F659, CF552A-F688,
CF552A-F695, CF552A-F556.
Manufactured by Summer Wind Limited.
Approximate maximum Weight: K9110L - 3.37 LBS,
K9120L - 3.3 LBS,K9115L - 3.52 LBS
Manual design and all elements of manual design are
protected by U.S. Federal and/or State Law, including
Patent, Trademark and/or Copyright law.
ASSEMBLY INSTRUCTIONS
for Fan Light Kit, Model# K9110L
READ AND SAVE THESE INSTRUCTIONS
SCREW
SWITCH CUP PLATE
CONNECTION
BLACK WIRE
PLUG
NUT BLUE WIRE
LOCK WASHER
SWITCH CUP
WHITE WIRE
LED LIGHT KIT
SWITCH CUP PLATE
SCREW
CONNECTION
PLUG
LED LIGHT KIT
GLASS SHADE
RUBBER WASHER
METAL WASHER
METAL NUT
METAL CAP
Special Note: The light kit can be dimmer by pull chain. Pull and
hold the pull chain to set the desired brightness. But it can not
be compatible with dimmer wall switch and dimmer remote
control.
Lock washer
SWITCH CUP
CENTER PLUG
Nut
SCREW
#K9120L
#K9115L
75
Wire nuts
LED LIGHT KIT
SWITCH CUP PLATE
Wire nuts
LED LIGHT KIT
GLASS SHADE
RUBBER WASHER
METAL WASHER
METAL NUT
METAL CAP