Siefken MAGNUM SBSOO3 Instrucciones De Uso página 14

3 YEARS
L I M I T E D WA R R A N T Y
Under excessive conditions, liquid can be expelled from the battery. This liquid can cause irrita-
tion or burns to the skin. Avoid contact. If contact accidentally occurs, rinse with plenty of
water. If the liquid comes into contact with the eyes, seek medical help immediately.
DO NOT open, disassemble, crush, incinerate, or heat above 60 ° C. Do not throw into re or the
like.
Battery installation
Place a charged battery pack by sliding it onto the base of the work light until it clicks and locks
in place.
NOTE: Make sure the battery and work light are properly aligned. If the battery does not slide
easily on the base of the work light, do not force it. In this case, slide the battery out of the work
light and check that the top of the battery and the battery slot of the work light are clean and
undamaged, and that the contacts are not bent.
Removing the battery
Remove the battery from the work light by pressing the battery release button; then slide the
battery out of the work light base WARNING: DO NOT attempt to remove the battery without
pressing the battery release button; otherwise, the guide or battery could be damaged.
Operating work light
Turn the torch on or o by pressing the on / o switch (4).
Adjust the focus direction (1) by turning the focus (1) with the swivel joint (2). It adjusts from 0
to 270 ° with 6 click stop positions.
Adjust the focus angle with the angle joint (3). It can be adjusted from 0 - 180 ° with 6 click stop
positions.
Note: Be careful not to damage the work light when adjusting the angle and turning positions.
The work light incorporates an integrated hanging hook (Image B). Push up to release it from
the tool body.
4