Dura Heat EUH1465 Manual De Instrucciones página 4

IMPORTANT: Read all instructions and warnings carefully before
installation and use. Failure to follow these instructions may result in a
possible electric shock, injury to persons, fire hazard and will void the
warranty
OPERATING INSTRUCTIONS
Setting
1. Position the fan heater so that it stands on a firm level surface and at a safe distance from
wet locations and flammable objects.
2. Connect the fan heater to the proper electrical power. See grounding instructions.
3. Set the power settings knob to fan or heating Position.
4. Set the thermostat dial to the maximum temperature.
5. Once the room reaches the desired temperature, turn the thermostat dial back until
heating element turns off. The heater will cycle automatically around this present
temperature. To increase temperature, turn the thermostat knob clockwise. To lower
temperature, turn the thermostat counterclockwise.
Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electrical shock and
Immediately call a qualified service technician to inspect the appliance
"SAVE THESE INSTRUCTIONS"
Function
Unit is off
Fan Is On – No Heat
Fan Runs –Half Power Low Heat
Fan Runs – Full Power High Heat
Thermostat Dial-Increase or Decrease the set temperature
Do not use this appliance if any part of it has been underwater.
and replace any part of the electrical system which has been under
injury to persons.
water.
~ 4 ~