Preparation; Unpacking; Handle - Briggs & Stratton BRUTE 7800583 Manual Para El Operador

Preparation

WARNING: Before doing any assembly or
maintenance to the mower, remove the wire
from the spark plug.
NOTE: In this instruction book, left and right describe the location of
a part with the operator standing behind the handle.

Unpacking

The mower was fully assembled at the factory. When the
mower was put in the carton, the handle was put in the
storage position. To put the handle in the operating position,
follow the steps below.

Handle

1. Remove the mower from the carton.
2. Remove all packing material from the mower and the
handle.
3. For all models except hi-wheel models, raise the lower
handle (A, Figure 1). Make sure the lower handle is
between the locking tabs (B). Tighten the lower wing-
nuts (C).
For hi-wheel models, remove the wingnut (A, Figure 2)
and bolt (B) from each handle bracket (C). Raise the
lower handle (D), and secure with the removed bolt and
wingnut.
4. Put the upper handle (D, Figure 1) in the operating
(upright) position. Tighten the upper wingnuts (E).
NOTE: The height of the handle can be set for operator comfort. See
"Handle Height".
CAUTION: Be careful when you fold or raise the handle. Do
not damage the cables. A cable that is bent will not work
correctly. Before you use the unit, replace a bent or damaged
cable.
5. Hold the engine stop lever against the handle. (Refer
to section entitled 'Engine Stop Lever'.) Slowly pull the
recoil-start grip (A, Figure 3). To attach the recoil-start
grip to the rope guide (B), twist the rope through the
rope guide mounted on the right side of the handle.
6
B
Figure 1: Unfolding the handle
B
Figure 2: Unfolding the handle (hi-wheel models only)
A
B
Figure 3: Attaching the recoil-start grip
D
E
A
C
D
A
C
www.brutepower.com