Technical Data - MO-EL 744 Uso Y Mantenimiento

For safety reasons, never attach the device near bath tubs,
wash basins, showers, or other fittings where there may be
water.
This hair dryer must be installed out of the range of a person
using the bath or the shower.
This machine can be installed and used in homes and hotels. The
distance shall be around 120 cm from the ground. Keep certain dis-
tance between the dryer and the door to avoid hit when opening and
closing the door.
1. Make 2 holes in the wall using the measurements shown in the
figure, then insert the dowels into the holes.
2. Secure the sliding plate (I) and then the support (D) to the wall
using 2 screws (H) provided.
The support (D) can be opened using the screws (L) for maintenance
(only by skilled personnel). You can use the hole (M) for the passage
of the power cord through an opening in the wall.
OPERATING
The hairdryer at rest must be kept with its cylindrical part contained
in the housing (E).
To operate the unit, pull it out from the housing taking it to the handle
(C), press the main switch (F) and then the ON-OFF switch (G) which
controls the emission of hot air. You can choose the power of the
air flow between two different values, by means of the selector (B).

TECHNICAL DATA

Power supply
Power
Air speed
Insulation class
AC 230 V ~ 50 Hz
540 W / 1200 W
8
15 m/s