Power On/Off - Intellinet GIGABIT SATA NAS Guía De Instalación Rápida

CONNECTIONS & CONFIGURATION
For further details on each of the settings, refer to the user manual.
1. Install one or two hard drives. NOTE: Without installing and formatting a drive first,
the other functions of the device won't be available.
2. Connect the Ethernet cable from your network router or switch to the device.
3. When everything is connected, turn the NAS on by pressing the Power switch. Give
it about two minutes to boot up.
4. On the included installation CD, run the INTELLINET_nas.exe utility. If needed, refer
to the manual's Section 3: System Setup / Logging In.
5. Access the Web configuration interface via your Web browser, then refer to Section
4: Web Configuration in the user manual.
6. Go to Section 4.2.5: Maintenance in the user manual and use the disk utility to format
the drive. If two identical drives are installed, you can also go to Section 4.2.5.2: RAID
Setting in the user manual and create your RAID array.
7. Once the drive is formatted, go to Section 4.1: Web Configuration / Basic in the user
manual and follow the quick setup wizard instructions. This will help you to set up
the IP configuration, add the first user and prepare file sharing, after which you'll be
ready to start sharing or downloading files. NOTE: Set the speed for your network
card to auto and not full or half speed.

POWER ON/OFF

To turn the power on, first connect the power adapter to the NAS, then plug it into an
AC outlet. Press the Power switch. The blue backlight LED will turn on, and the unit will
start to boot up. It will take about a minute for the device to go online and be ready.
During bootup, the OS LED will blink.
To turn the power off, log in via your Web browser, stop all current downloads, go to
the "Turn Off Server" screen (Section 4.2.3: System), and turn the server off or use the
Power switch. The OS LED will be blinking for about 5 seconds; the system will shut
down about 20 seconds later. NOTE: If the device is not in use for a longer period of
time, remove the power adapter from the AC outlet.
IMPORTANT: To protect your files and help prevent the loss of your data, it's strongly
recommended that you keep two copies of your data: one copy on your Gigabit SATA
NAS and a second copy either on your internal drive or another storage media, such as
a CD, DVD, tape or additional external drive. Any loss or corruption of data while using
this Gigabit SATA NAS is the sole responsibility of the user, and under no circumstances
will INTELLINET NETWORK SOLUTIONS be held liable for compensation or the recovery
of this data.
Package Contents
• Gigabit SATA NAS
• Power adapter
4
ENGLISH
• Quick install guide
• CD with user manual