Uline H-3864 Instrucciones De Funcionamiento

π H-3864
STAINLESS STEEL
DRUM PUMP
IMPORTANT! This pump is made out of 304 stainless steel and PTFE. Use chemicals compatible with these
materials and follow O.S.H.A. guidelines when using this pump including proper grounding and protective
gear as required. Unit not U.L. or FM approved.
1. Slide pump cylinder into drum opening.
2. Loosen thumbscrew. Turn drum adapter into drum
opening. Position the pump and hand tighten the
thumbscrew.
NOTE: No tools necessary. Excessive tightening
will crush the pump barrel.
3. Install spigot into the cylinder head and tighten the
spigot collar.
NOTE: Cylinder head has a standard 1/2"
garden hose connection for easily attaching
a garden hose to the pump discharge.
π
PAGE 1 OF 3 CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
T-Handle
Spring
Piston Rod
Packing Nut
Ground Stud
OPERATING INSTRUCTIONS
Spigot
Spigot Collar
Thumbscrew
Drum Adapter
Pump Cylinder
4. Use short quick strokes to start pumping action. Then
regulate stroke speed to obtain desired discharge.
5. After prolonged use, liquid may seep at the shaft.
Tighten the packing nut to eliminate seepage.
NOTE: Packing nut will last the life of the
pump. No need to replace in normal use. Three
additional packing nuts are included if original
is damaged or misplaced.
6. If the pump fails to prime or deliver full volume: rinse
thoroughly with hot water or solvent to loosen caked
or solidified chemical deposits and free valve plates.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0515 IH-3864