Temper KOBAN KDP Manual Del Usuario página 15

Button
To lock KDP buttons
By pressing this button, KDP buttons will be locked and no key
function is workable (Except
Unlock KDP buttons
• By pressing this button, KDP buttons will be unlocked.
Thereafter, the remote controller can be used to set presence
detector.
• The default channel is CH1 (Load I) after unlocking KDP.
• When operating KDP to detector under unlock mode,
detector will lock automatically 5min after the last operating
if
Ex-changing auto mode and semi auto mode
By pressing this button, firstly, detector enters into auto mode
with detector's red LED flashing quickly for 2sec no matter it is
locked or not. Then, press it again, detector enters into semi-
auto mode with detector's red LED keeps on for 2sec.
The previous setting values can be stored and duplicated to
other detector
1. Set the desired Lux and time values on one detector by using
the remote controller.
2. Then by pressing MEMO button for approx. 3sec aiming to
above detector, the Lux and time settings of this detector
will be saved into this remote controller by detector's LED
flashing.
3. By pressing MEMO button again for approx. 1sec aiming to a
new detector, the saved settings can be duplicated to the one.
4. Transfer the settings to detectors desired by repeating above
last step. If no data is saved in the remote controller, detector
has no reaction after press MEMO button.
5. Battery removed for more than 5sec or MEMO button is
pressed, all the data in IR remote controller will be deleted.
To reset settings on presence detector
By pressing RESET button aiming to the detector, all settings on
presence detector will go back to potentiometers' settings, and
all MEMO data will be deleted.
www.grupotemper.com
button is not pressed.
Remote control
Function
button).
Instructions manual |
KDP
15