Brandson Equipment 303495/20200605NB093 Manual De Usuario página 12

6. Commissioning
Take the device out of the package and remove all the packaging material. Before
using the product for the first time, charge it completely. To do this, take one of
the supplied power adapter and connect it to the power source (electrical socket
or car mains socket) and the device. The battery level indicator is located on the
device display.
6.1 Operation
1. Connect the device to the air hose or car valve adapter. All the other sup-
plied adapters can be attached to the end of the air hose.
2. Press the "UNIT" button repeatedly to select the pressure unit (PSI, bar, kPa
or kg / cm²). Adjust the desired pressure using "+" and "-".
3. Press the "ON/OFF button, to start the pumping. During the pumping, the
LED on the side of the compressor starts glowing.
4. If the inflatable object reaches the adjusted pressure, the pump automati-
cally stops the pumping process. Press the " ON / OFF" button to turn the
LED off. The pumping can be stopped manually at any time by pressing the
"ON / OFF" button.
5. Disconnect the air hose along with valve, after pumping is complete.
6. Store the compressor in a dry and clean place.
During charging, you can prevent the device from turn on accidentally by pressing
and holding the "UNIT" button by switching it on ("ON") or off ("OFF").
7. Air pressure measurement function
Connect the device to the object to be measured and press the "UNIT" button.
The display now shows the actual tyre pressure.
8. Standby function
If the device does not detect any pressure when the pump is running, it turns off
automatically after about 60 seconds.
12
English