Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Rules and Instructions: Extension Cords
Double insulated tools have 2-wire cords and can be used with 2-wire
or 3-wire extension cords. Only round jacketed extension cords should be
used, and we recommend that they be listed by Underwriters Laboratories
(U.L.) (C.S.A. in Canada). If the extension will be used outside, the cord
must be suitable for outdoor use. Any cord marked as outdoor can also
be used for indoor work. An extension cord must have adequate wire size
(AWG or American Wire Gauge) for safety, and to prevent loss of power
and overheating. The smaller the gauge number of the wire, the greater the
capacity of the cable, that is 16 gauge has more capacity than 18 gauge.
When using more than one extension to make up the total length, be sure
each individual extension contains at least the minimum wire size. Before
using an extension cord, inspect it for loose or exposed wires, damaged
insulation, and defective fittings. Make any needed repairs or replace the cord
if necessary.
Volts
To determine the
120V
minimum wire size
240V
required, refer to
Ampere Rating
the chart:
More Not more
Than Than
0
-
6
-
10 -
12 -
Safety Rules and Instructions: Polarized Plug
To reduce the risk of electric shock, this equipment has a polarized plug
(one blade is wider than the other). This equipment must be used with a
suitable polarized 2 wire or 3 wire extension cord. Polarized connections will
fit together only one way. Make sure that the receptacle end of the extension
cord has large and small blade slot widths. If the plug does not fit fully into
the extension cord, reverse the plug. If it still does not fit, obtain a suitable
extension cord. If the extension cord does not fit fully into the outlet, contact
a qualified electrician to install the proper outlet. Do not change the tool plug
or extension cord in any way.
Minimum Gauge for Cord Sets
Total Length of Cord in Feet
0-25
26-50
51-100 101-150
0-50
51-100 101-200 201-300
American Wire Gauge
6
18
16
16
10
18
16
14
12
16
16
14
16
14
12
Not Recommended
The label on your tool may include the following symbols.
V ............... volts
Hz ............. hertz
min ............ minutes
.......... direct current
.............. double insulated
............ safety alert symbol
14
12
12
1. Blower Tube Release Button
2. On / Off Switch
3. Blower Opening
4. Fan Cover
4
A ....................amperes
W ...................watts
..................alternating current
n o ...................no load speed
....................earthing terminal
.../min .............strokes per minute
COMPONENTS
1
6
3
5
7
5. Blower Tube (2 pieces)
6. Vacuum Tube (2 pieces)
7. Collection Bag
2
4
Publicidad
Tabla de contenido
