B&G IS-2503 Instalación página 7

installation
panel mounting
Ensure there is sufficient room behind the panel to accommodate the fixings and connections, and using the
template supplied, cut a hole in the panel in the desired position.
Fix the mounting bracket into the hole using the screws supplied.
Note: The sealing ring is fitted to the unit during manufacture. It's purpose is to prevent moisture penetration
and reduce the effects of any vibration transmitted through the instrument panel.
Press the Display into the mounting bracket; an audible 'click' will indicate that the case is correctly located.
Secure the unit to the instrument panel by fitting the studs and thumbnuts supplied.
Caution: To avoid damaging the casing, fixing studs must only be tightened 'finger-tight'.
Fit the optional snap-on bezel, if required.
Sealing Ring
(Fitted at Manufacture)
Mounting
Bracket
Snap-On
Bezel (Optional)
Display
Unit
Protective
Cover