Fig. 14 - Coolaroo 457020 Manual De Instrucciones

C. Next press the middle (stop) button once. Your shade will
walk (up and down) and beep once. (Fig. 14)
D. Then hit the middle (stop) button one final time and your shade
will beep 3 times. This will signal your third position is now set.
E. To use your third position, press and hold the middle (stop)
position at any time and your shade will move to your set third
position location.
7
CANCEL THIRD POSITION
To adjust the third position after it has been set, you will first need to
cancel the current third position location.
A. Remove the back of your remote and hit the P2 button once.
Your shade will beep once and walk (up & down). (Fig. 15)
B. Next hit the middle (stop) button once. Your shade will beep
once and walk (up & down). (Fig. 14)
C. Then hit the middle (stop) button one last time. Your shade will
beep 3 times. This will signal your third position is now cleared
and ready for resetting.
Retract your roller shade when not in use, or before strong storms, to prevent damage.
MAINTENANCE: Your sun shade has been made of the finest materials and, when properly cared
for, will provide years of shade and privacy. To clean your shade, simply rinse with water, scrub with
mild soap or any nonabrasive cleaner, rinse and allow to dry. Call us for missing parts or mechanical
problems. Do not store shade wet. In moist areas, roll shade down frequently to air dry.
CAUTION: Use of solvents or abrasive cleaners may damage the fabric and will void your warranty. Do
not use bleach or chlorine.
Questions or Comments? Contact us at:
Gale Pacific USA, Inc. | www.coolaroousa.com | 1-800-560-4667
© by Gale Pacific Limited. All rights reserved. Coolaroo® is a registered trademark of Gale Pacific Limited.
INSTALLATION
INSTRUCTIONS

Fig. 14

Fig. 15
Register and Order
Replacement Parts Online:
www.coolaroousa.com
5.04.004.267