Familiarizing Yourself With The Functional Principle; Familiarizing Yourself With Permissible Materials; Preparing The Multifunction Tool; Mounting The Handle - Workzone WMW 300-2 Manual Del Usuario

All manuals and user guides at all-guides.com

Familiarizing yourself with the functional principle

The multifunction tool does not rotate the fitted tool; instead, it oscillates it back
and forth.

Familiarizing yourself with permissible materials

You can use the following tools to process the listed materials:
Plunge-cut saw blade
• Hard and soft woods
Scraper
• Layers of paint and lacquer
• Synthetic coatings
• Flexible floor coverings, e.g. carpets, linoleum
Segment saw blade
• Hard and soft woods
Sanding plate
• Hard and soft wood surfaces
• Layers of paint and lacquer

Preparing the multifunction tool

CAUTION!
Risk associated with oscillating moving parts!
If you accidentally switch the multifunction tool on, you could
injure yourself on the moving parts that are oscillating.
− Before mounting accessories, disconnect the
multifunction tool from the power supply.

Mounting the handle

− Screw the handle
you screw the handle onto the left side of the multifunction tool if you are
right-handed and onto the right side if you are left-handed.
Connecting the dust extractor
1. Mount the extractor line
multifunction tool (see fig. B and M). Make sure that the extractor line is
correctly positioned on the multifunction tool.
AFTER SALES SUPPORT
USA 1 866 326 6446
onto the multifunction tool (see fig. C). Make sure that
6
17 with the holding clips
meister-service@meister-werkzeuge.de
Preparation
2 onto the back of the
USA
15