Getting Started - HDMX Audio HMDX-S50 Manual De Instrucciones E Información De Garantía

Getting Started

1. Attach the DC adaptor to the DC Jack located on the back of the unit.
(Fig. 3)
2. Plug the cord into 120V household outlet.
Charging your iPod™
1. Select the correct insert for your particular iPod model from the
chart below:
Insert Label iPod Model
2G nano iPod nano 2nd Generation
nano-3 iPod nano 3rd Generation
video 30G, 80G 5G iPod with Video (30GB), U2 iPod with Video, iPod classic
classic/touch (80GB), iPod touch
video 60G, 160G
5G iPod with Video (60GB, 80GB), iPod classic (160GB)
classic
When you want to connect a different size iPod, remove the insert from the
dock and replace with the correct size insert. To remove dock insert, place
fingernail in slot on insert (Fig. 2) and gently pull up. You must always use
the appropriate size insert for your iPod. If you do not find the correct
matching dock insert listed above to your iPod model, you may use the
dock adapter insert that was included with your original iPod purchase or
call HMDX AUDIO Service Center at 1.800.466.3342 to purchase one.
Note: Make sure you are using the correct insert for your iPod and
that it is properly placed in the dock of the unit. Failure to do so
may damage your iPod.
WARNING:
INSERTS AND PIN CONNECTOR ARE DESIGNED FOR
APPLE iPOD MUSIC PLAYERS ONLY. ATTEMPTING TO ATTACH OR
FORCE ANY NON-iPOD MUSIC PLAYER INTO ENCLOSED INSERTS
OR ONTO THE PIN CONNECTOR WILL DAMAGE AND EVEN
DESTROY YOUR DEVICE.
6
2. Remove your iPod from its case or 'skin'. Place insert in dock, being sure that the
two plastic tabs face the front of the unit. Press insert into place, ensuring it is firmly
placed in the dock (Fig. 2). Carefully place your iPod into the docking area so that
the pin connector in the dock is fully connected to the pin socket on the bottom of
your iPod (Fig. 5). You will hear a "chirp", indicating that your iPod is properly
connected.
3. Your iPod will begin charging, until fully charged.
Note: Your iPod will charge even if the POWER button is turned off.
The unit only needs to be plugged in for the iPod to charge.
4. To remove/replace an insert, first remove your iPod then insert fingernail in
slot on insert (Fig. 2), and gently pull up.
Figure 5
Charging your Speakers
You can take your HMDX S50 speakers with you and play your music wherever
you want, no wires required!
Line up notch in back of speaker base (Fig. 4) with notch in the charging pad on
the base unit (Fig.1). When speaker is placed in recharging cradle properly, an
indicator light on the base of speaker will glow red for recharging, or green for
fully charged (Fig. 4) The speakers will charge in recharging cradle with the unit
plugged in even if the POWER button is turned off.
Note: For best results keep wireless speakers within 150 feet range
from the base unit. Some building materials and location of the base
unit or wireless speakers can affect transmission quality and range.
Try various locations for best results.
Note: It can take approximately 3 hours to fully charge your speakers
initially. When fully charged, your speakers will have up to
approximately 5 hours of use.
7