Aqua Medic DC Runner 1.2 Manual De Instrucciones página 9

Fig. 3: DC Runner 5.0
1. Rubber feet
2. Holding plate
3. Pump motor
4. Rear bearing
5. Impeller rotor
6. Housing's sealing
Art.-No. Pict.-No.
100.350-1 1/2
100.350-25 4
100.350-31 4/5
100.350-28 6/8
100.350-10 7
100.135-20 8/9/10/11
100.350-14 12
The pump may only be operated with
water depth is 1 m / 40 in.
Safety advices
The pump is constructed for indoor aquarium use only. Before working on the
6. EcoDrift Control
aquarium, the power plug must be disconnected from the mains.
The connection cable and the power plug must not be changed. If the power cable is damaged,
the pump must be scrapped.
4. DC Runner Controller
The included DC Runner
The power can be adjusted by pressing the +/- buttons, the level is displayed by LED. If you press
the button „FEED", the output will stop for 10 minutes.
There is an automatic shut off if there is no water for 2 minutes. Pull the plug and then re-insert it
to take the controller back into operation.
Controller, plugs and sockets have to be kept dry.
7. Pump lock
8. Seal for pressure connections
9. Adhesive sleeve D 32
10. Hose connection
11. Union nut
12. Filter basket
Article
Bottom plate with rubber suckers
Rubber bearing and ceramic insert
Impeller cpl.
Set O-rings
Pump lock
Set of connections
Filter basket
water. An installation out of water is possible. The max.
Controller is switched between power supply and pump to adjust the output.
9