Publicidad
Idiomas disponibles
Idiomas disponibles
P P
R R
E E
P P
A A
R R
A A
T T
P P
R R
E E
P P
A A
R R
A A
1.a Before using the vacuum cleaner, assemble the handle
(1)
2.a Remove the locking screw (5) from the handle (1) and
locate it in the power plant (2) (fig. 1)
3.a Tighten the screw (5) with the wrench n. 6 supplied,
turning it clockwise (fig. 2)
4.a Fix the rotating hooks for cable storage (3) in the holes
of the handle (1) by pushing them until they are
correctly located.
S S
U U
S S
U U
The appliance is now ready to operate
1.b Connect the accessory required for the cleaning
operation.
2.b Connect the supply cable to the mains and push the
mains ON/OFF switch
3.b Variable suction (7) allows you to control the suction
power according to the surface to be cleaned.
4.b By moving the variable suction slider (7) to the left in
the max direction, the power of the appliance will
increase
The minimum position is suggested for curtains.
The medium position is suggested for carpets and upholstery.
The maximum position is suggested for hard floors.
M M
A A
I I
N N
M M
A A
I I
N N
Before any kind of maintenance, make sure that the supply
cable is not connected to the mains.
REPLACING THE DUST BAG
1.c When the dust bag is full, the indicator light (8) will go
from green to red (fig. 5). The fullness of the bag can only
be correctly seen when the appliance is operating at
maximum power (regulator turned towards max mark).
2.c Lay the appliance on the floor.
3.c Remove the cover (9) (fig. 6) by pushing the opening
button.
4.c Take out the dust bag support (12) by pushing it
backwards and then lift it by holding the flap (Z), paying
attention not to damage it.
ENGLISH
I I
O O
N N
F F
O O
R R
U U
S S
E E
T T
I I
O O
N N
F F
O O
R R
U U
S S
E E
C C
T T
I I
O O
N N
C C
T T
I I
O O
N N
T T
E E
N N
A A
N N
C C
E E
T T
E E
N N
A A
N N
C C
E E
Fig. 1
Fig. 2
Fig. 3
Fig. 4
7
6
Fig. 5
Fig. 6
Publicidad
