Change A Stored Number; Dialing A Number In Memory; Troubleshooting - Walker W-400 Manual De Usuario

5. Press a number key (0-9) for the memory location
where the number is to be stored.
6. A long beep will confirm the number has been
successfully stored.
NOTE: If a 17th digit is accidentally pressed or a pause
of more than 30 seconds occurs during programming,
an error tone will sound. Try again. Each TONE (*)
or PAUSE entered uses one of the 16 available
memory digits.
If you experience difficulty operating your cordless phone,
try the suggestions below.
If the trouble persists, call the WALKER EQ UIPMENT
Customer Service Department Toll Free Help Line at
1-800-552-3368, Monday - Friday between the hours of
8:00 a.m.-5:00 p.m. (EST)
THE UNIT WILL NOT OPERATE/NO DIAL TONE:
• Make sure the TALK B UTT ON is lit.
• Make sure the AC adapter is plugged into base unit
and wall outlet.
• Make sure the telephone line cord is plugged into the
wall jack.
• Make sure the base antenna is in an upright position.
• Make sure the handset battery is fully charged.
8
Operations

CHANGE A STORED NUMBER

Replace a stored number by programming a new number
in its place.
DIALING A NUMBER STORED IN MEMORY
1.Lift the handset. Press TALK.
2.With TALK button lit, press MEMO .
3.Press memory location (0-9) assigned to number
being called.

Troubleshooting

• Make sure you have selected the correct dialing mode,
tone (touch) or pulse (rotary).
• Make sure you are within the usable range of the
base station.
• Reset the security code by placing the handset in the
base for 5-10 seconds.
THE PHONE DOES NOT RING WHEN
YOU RECEIVE A CALL:
• Make sure the RINGER switch on the base is
turned ON.
• Make sure the AC adapter is plugged into the base
unit and wall outlet.
• Make sure the telephone line cord is plugged into the
wall jack.