Advel Genesis 71210-20310 Guía De Referencia Rápida página 6

Genesis
®
Quick Release Nose Equipment
To P r e p a r e B a s e To o l t o A c c e p t Q u i c k R e l e a s e N o s e E q u i p m e n t
(Refer to the relevant Genesis
•
For nG3/4, G3/4 and G2/G2s tools remove Jaw Spreader Housing 71210-02101.
•
For nG1, nG2 and nG2s tools remove 'T' Adaptor 71213-02020.
•
Replace above part with 'T' Adaptor (item 6). Note: For nG3/4 tools 'T' Adaptor (item 6) is assembled through Nose Case Adaptor
Assembly (items 2, 3, 4, 5 and 8).
•
Screw the Nose Case Adaptor Assembly (items 2, 3, 4, 5 and 8) into the front of the tool.
•
The Nose Equipment Cartridge (item 9) is assembled onto the 'T' Adaptor (item 6) by sliding in a plane normal to the Piston.
•
Push the Quick Release Nose Casing (item 7) into the Nose Case Adaptor (item 5) ensuring flats are aligned, this locks the Quick
Release Nose Casing into position.
To R e m o v e t h e Q u i c k R e l e a s e N o s e E q u i p m e n t
•
Rotate the Quick Release Nose Casing (item 7) through 90 degrees and pull out of the Nose Case Adaptor (item 5).
•
To release the Nose Equipment Cartridge (item 9) from 'T' Adaptor (item 6) slide cartridge in a plane normal to the head Piston.
QUICK RELEASE NOSE CASING (7)
Item numbers in bold refer to the Parts List on the front page.
®
Tool Instruction Manual.)
ALIGNED SPANNER FLATS (LOCKED POSITION)
NOSE CASE ADAPTOR (5)