Technical Data; Package Includes; Handle Assembly; Thermostat Control - Perfect Aire 1PHF3P14 Manual De Usuario

TECHNICAL DATA

• Amps: 12.5
• Wattage: Low 1300W,
• Working voltage: 120V AC/60Hz
ASSEMBLY INSTRUCTIONS
Carefully remove the heater and all parts from the box. We
recommended you save the carton for off-season storage.

Package includes:

1 - Heater
1 - Carry Handle
2 - Screws

Handle Assembly:

1. Place the heater in an upright position.
2. Use the provided screws to attach the carry handle on
top of the heater housing (See Figure 1, below).
3. Use a phillips screwdriver to tighten the screws firmly.
Please ensure that screws are not overtightened.
Figure 1
NOTE: THIS UNIT IS FOR FLOOR USE ONLY.
OPERATING INSTRUCTIONS
1. Place the heater on a firm level surface.
2. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500 Watts,
this unit draws 12.5 Amps.
Mode Settings
1. To start heater operation, turn Thermostat control
clockwise to the highest setting.
2. Switch the control knob to your desired heat setting:
OFF - No Function
FAN - Fan Only
LO - Low Heat
HI - High Heat
3. The Power Light will remain on during operation.
F E AT U R E S - O P E R AT I O N S
High 1500W (+5% -10%)

Thermostat Control

Turn the Thermostat Control knob clockwise (to
1.
the right) to start the heater.
When the desired temperature/comfort level is
2.
reached, lower the temperature setting by turning
the Thermostat Control knob counter-clockwise (to
the left).
3. The thermostat will now automatically maintain the
pre-set temperature level by turning the heater ON
and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, raise the temperature setting.
Figure 2
D
C
B
A
Figure 3
CONTROL PANEL
B
C
E
A. Power Indicator
B. Thermostat Control
Knob
C. Mode Knob
D. Protective Guard
Rails
E. Carry Handle
A
A. Power Light
B. Control Knob
C. Thermostat Control