Celestron LABS CM800 Manual De Instrucciones página 2

3. For higher powers, rotate the nosepiece
(3) to change the objective lens (4)
to 10x or 40x. This will yield a greater
magnification. Gradually turn the focus
knob (11) to refocus on the specimen.
NOTE: You should first turn the focus knob
to lower the stage, before turning the
objective carriage.
4. You can replace the WF 10x eyepiece
with the WF 20x eyepiece to obtain three
additional high power magnifications,
including (800x) the highest power
possible.
ADJUSTING THE
ILLUMINATION
Specimens of different sizes, thickness
and color variations will require different
levels of illumination. In order to adjust
illumination, turn the illuminator adjustment
wheel (14) to either increase or decrease
the illumination. The illuminator adjustment
wheel (14) has three illumination settings
(I being the lowest and III the highest).
Optimal lighting is found by making
adjustments and experimenting.
DIAPHRAGM
The disc diaphragm (12) has six diameter
openings. These openings allow you to
adjust the amount of light passing through
the specimen. Adjusting the light can help
you maximize brightness, contrast, etc.
CARE, MAINTENANCE AND
WARRANTY
Your Celestron Labs microscope is a
precision optical instrument and should be
treated with care at all times. Follow these
care and maintenance suggestions and your
microscope will need very little maintenance
throughout its lifetime.
• When you are done using your
microscope, remove any specimens left
on the stage.
• Turn off the power and unplug the power
cord (if applicable).
• Always place the plastic bag or dust cover
over the microscope when not in use to
help keep it clean.
• Store the microscope in a dry, clean place.
• Be very careful if using your microscope
in direct sunlight to prevent damage to
the microscope or your eyes.
• To carry your microscope, place one hand
on the "arm" of the microscope and the
other hand under the base for support. Do
not grasp your microscope by the focuser
knob or head.
• Clean the outside surfaces (metal and
plastic) with a moist cloth.
• Always unplug any cords before cleaning.
• Never clean optical surfaces with cloth or
paper towels as they can scratch optical
surfaces easily. Instead, use an air blower
or camel hair brush.
• To clean fingerprints off of optical
surfaces, use a lens cleaning agent
and lens tissue available at most photo
supply stores. When cleaning, do not rub
in circles as this may cause streaks or
scratches.
• Never disassemble your microscope or
clean internal optical surfaces. Only
qualified technicians at the factory or an
authorized repair facility should attempt
these repairs.
• When handling glass specimen slides, use
care, as the edges can be sharp.
YOUR MICROSCOPE HAS A
TWO YEAR LIMITED WARRANTY.
FOR MORE DETAILED INFORMATION,
PLEASE VISIT
www.CelestronLabs.com
Torrance, CA 90503
TEL (800) 421-9649
www.CelestronLabs.com
Copyright 2014 Celestron
All rights reserved.
(Products or instructions may change
without notice or obligation.Designed and
intended for those 14 years of age and
older.