Keypad Code; Read Key; Write Key - Paradox ESPRIT 642BL Guia De Instalacion

[3] Keypad Code

Use this option to change the Keypad Code (default: 0000). After
entering Keypad Programming Mode, select section [3]. Enter the
new four-digit keypad code. During the keypad's power up, the
display reads: for keypad reset enter and clear.
To set the keypad code to default, press and hold the [ ] key.
ENTER
Without releasing the [ ] key, press and hold the [ ] key.
ENTER CLEAR
Hold both keys until the display shows the system status.

[4] Read Key

Use this option to copy the programmed options and labels
(messages) from a Paradox Memory Key to the keypad's memory.
Insert a programmed Paradox Memory Key into the keypad
connector labelled "key" (see Figure 1 on page 29). After entering
Keypad Programming Mode, select section [4] and then press the
] key. The display reads: Reading Key. The keypad will
[
ENTER
copy the contents from the key into keypad memory. This may take
approximately 15 seconds. Once the information has been copied,
the keypad will emit a confirmation beep.

[5] Write Key

Use this option to copy the programmed options and labels
(messages) from a keypad to a Paradox Memory Key. Insert the
Paradox Memory Key into the keypad connector labelled "key" (see
Figure 1 on page 29). Make sure the Memory Key's jumper is on.
After entering Keypad Programming Mode, select section [5] and
then press [ ]. The display will read: Writing Key. This may
ENTER
take approximately 15 seconds. When the process is complete, the
keypad will emit a confirmation beep. Program one keypad, copy its
contents to the memory key as explained in this option, then program
as many keypads as required using option [4] (see above).
Esprit+ (642BL) 9