Important; Install Leveling Legs; Install Shelves - Whirlpool Gladiator Garageworks GAJG36GRDG Instrucciones De Ensamblaje

P1
P3

Install Leveling Legs

(optional)
IMPORTANT: If you are going to install the cabinet on Gladiator
®
GearWall panels or GearTrack
leveling legs.
1. Place the cabinet on its side.
2. Screw a leveling leg (P4) into each of the four rivet nuts located at
the corners of the cabinet as shown.
P1
A. Leveling legs
3. Stand the cabinet upright.
4. If you have not already done so, fasten the two bolts at each
front corner, of the cabinet frame. Completely tighten all of the
cabinet bolts and nuts.

Install Shelves

IMPORTANT:

The shelves are supported by the metal slots on the cabinet
sides.
Make sure the magnet in the right of each long shelf edge is
facing out.
P2
P1
®
channels, you do not need to install
P4
P3
A
1. Place a shelf (P5mr) so that the 2 tabs in the shelf ends are
aligned with the pair of slots in the middle of the cabinet sides.
P1
2. Tilt the shelf so that one end is higher than the other as shown.
B
A. Push down.
B. Lift up.
3. Insert the shelf into the cabinet so that the higher end is directly
above the desired slots and push the shelf down into place
behind the side slots. Raise the lower end so it is directly above
the desired slots and push the shelf down.
NOTE: You may need to slightly bend the shelf tabs outward for
the tabs to engage in the slots. Make sure the shelf tabs are in
place behind all the slots, as shown.
A. Cabinet slot
B. Shelf tab
P2
P1
P5mr
P3
A
A
B
5