Technical Data; Buttons Description - GAPOSA QC19 Manual Del Usuario

QC 19
Remote Control Unit for shutters and awnings
IMPORTANT: READ CAREFULLY THESE INSTRUCTIONS
- In case of doubts about the installation, contact a qualified technician
- Disconnect supply during installation or whatever maintenance on the control
QC19 control unit for shutters and awnings is provided with a redio receiver (434,15MHz) and a
facility for a pushbutton and a wind sensor. It is in a water resistant box with a projection antenna.

TECHNICAL DATA

Power supply
Max. motor power
Frequency
The receiver can record up to 28 different codes to identify as many transmitters.
The shutter/awning is controlled by a transmitter and/or an external standard switch (normally
open). You can also install a wind sensor QCWS (option) which closes the awning automatically in
case of strong wind.
Jumper J1 - in: wind sensitivity 15 Km/h;
- out: wind sensitivity 30 km/h;
The transmitter has a range of 20 mt. indoor and 300 mt. outdoor.
Max. distance between wind sensor and QC19 is 30 mt.
ATTENTION: If you install several QC19 in the same room, during the first
installation you will have to supply and set each unit at a time in order to avoid
any interference (loss of programming or rotation inversion).

BUTTONS DESCRIPTION

PROG-TX = sets the transmitter
STOP = the motor stops
CE Marking and Compliance
The receiver and the radio transmitter complies with the requirements of European and
National norms. Conformity has been tested and the relevant certificates and documents
are available by the manufacturer.
230VAC 50-60Hz
500W
434,15 MHz
UP = the motor lifts the shutter/awning
DOWN = the motor closes the shutter/awning
Dimensions
126X41X25mm
Weight
100g
IP
55