Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. PlOT THE lOCATION
Before building your canopy, choose a flat area and plot your location.
A. With enclosed Spikes (10431), stake out the area for the canopy in the desired spot.
The width (W) of the area should be at least equal to the width of the canopy (18 FT.)
and the length should be at least equal to the length (L) - 30 FT.
B. To be sure the staked area is square, tie a rope diagonally from corner to corner.
C. Measure from where the two ropes intersect each other to all 4 corners. These
measurements (A and B) should be the same. If they are not equal the spikes need to
be adjusted until the width, length and inside measurements are correct.
2. lAY OUT ROOF FRAME
• Assembly is easiest if you lay out the roof parts as shown in the location you intend to erect the shelter.
• Start by assembling the center peak then assemble each side.
• All connections will use 2
10045
802105
10244
802105
10047
10244
802105
10047
10244
802105
10047
10244
802105
10047
10244
802105
10045
/
1
inch (# 10017) bolts, EXCEPT where noted (
2
10046
802104
802104
10244
10048
802104
802104
10244
10048
802104
802104
10244
10048
802104
802104
10244
10048
802104
802104
10244
802104
10046
802104
10045
802105
10244
10047
802105
10244
802105
10047
10244
802105
10047
10244
802105
10047
10244
802105
10045
Page 4
18 ft. W
A
B
) use 2 inch (# 10114) bolts.
NOTE:
Install all
carriage bolts with the
nut toward the center
of the frame.
05_26767_0F
30 ft. L
Publicidad
Tabla de contenido
