Raycap AC2100 Serie Instrucciones De Instalación

INSTALLER MATERIALS CHECKLIST
The following materials checklist is provided to assist in installation preparations. Installers may find it helpful to
verify that all materials are available.
Circuit breaker, check product labeling for breaker requirements.

Conduit and fittings, 3/4 inch for AC power.

 Punch for distribution panel, 3/4 inch conduit (26 mm).
 Wire strippers
GENERAL INSTRUCTIONS
The Surge Protective Device (SPD) mounts directly to the service panel to be protected. Whenever possible, use
the first circuit in the service panel. Wire lengths of 24" (60 cm) or less are desirable. The shortest possible wire
length enhances the suppressor's performance by allowing less let-through voltage into the protected equipment.
INSTALLATION AND CONNECTION OF SUPPRESSOR
 Install the SPD breaker. NOTE: Not all products require a separate SPD breaker. Check product labeling
for requirements
 Find and mark a suitable location (3/4 knockout preferred) for mounting the suppressor to the distribution
panel.
320-0221 REV D
AC2100/AC21SM/AC4100 SERIES
INSTALLATION INSTRUCTIONS
Location of Suppressor
Shown with SPD breaker
Page 1 of 4