Wireless Mode - Matco Tools IXP7 Instrucciones De Operación

Operation
Powering ON
Press and Hold "ON/OFF" button for 2 seconds to power ON, the Blue LED will start to flash. If an Aux (3.5 mm) cable is connected to the unit, the Blue LED will turn
off, and the Green LED will stay illuminated, notifying you the unit is in Aux-In mode.
Powering Off
Press and Hold "ON/OFF" button 2 seconds to power OFF.

Wireless Mode

Pairing
The unit will automatically go into "PAIRING MODE" when it is powered ON. Go into your Wireless device settings menu and look for "Matco16". After the unit has
paired and connected, it will re-connect automatically when the unit is powered on and the device is in range.
Note: Wireless Timeout: 10 minutes
Begin Streaming Music
Press " " to start playing music
Press and Hold " " 2 seconds to play the next track
Press and Hold " " 2 seconds to play previous track
Press either " " or " " for volume control
Making and Receiving Phone Calls
When the unit is connected and paired to your device, the unit allows you to make or receive phone calls with its built-in microphone. Press "
To end a call press " ". To place a call, simply dial the number or select a contact from your Wireless device and call. To reject a call, press and hold "
seconds.
Aux-In Mode
Plug in the supplied 3.5mm cable into the unit. The other end is connected to your device. The Green LED will only illuminate when in "Aux" mode. Please note music
and volume can be controlled by your device.
Charging
Attach the USB cable to the unit, and plug into any suitable USB charger. If the unit is completely discharged, it will take approximately 4 hours to fully charge.
The Red LED will illuminate during charging, when it has completed, the Red LED will turn off.
Note: There will be a beep when the battery is low and needs to be recharged.
LED Status.
Blue LED flashing & Blue LED
solid
Green LED on solid
Red LED
MTCWPSG/MTCWPSM
Troubleshooting.
Wireless Mode
Unit doesn't connect to device
AUX mode
Charging
MTCWPSG
MTCWPSM
PROBLEM
A tone is heard every few
seconds
Unit will not power on
Unit doesn't control Speaker needs to be in Wireless mode for
track(s)/volume
Unit distorts at
high volume
2
" to accept a call.
ACTION
Speaker needs to be connected/
re-paired to device
Speaker needs to be charged
Speaker needs to be charged
full control
The devices' volume needs to
be lowered
" for 2
02/24/20