Care And Cleaning - Glacier bay 2623NNHD Guía De Uso Y Cuidado

[Heading goes here]
Installation (continued)
9
Mounting the unit to the wall
NOTE: For safety reasons, it is imperative that this unit
be mounted to the wall.
NOTE: Before cutting, drilling or hammering into any wall
surface, verify the location of electrical, plumbing and gas
lines. Cutting any of these may cause serious injury.
□ Mark mounting points on the wall through the holes in
the rear tubes of the unit.
□ Hammer wall anchors (GG) into the wall, unless the
mounting screws (FF) will go directly into a stud.
□ Place the unit against the wall, lining up the wall
anchors (GG) and holes in the rear tubes.
□ Tighten the mounting screws (FF) into studs or wall
anchors (GG).

Care and Cleaning

□ Cleaning with a dry cloth may be sufficient.
□ For other stains or marks, wipe gently with a damp cloth.
□ Do not use strong detergents or abrasive cleaners; they may damage the surface of this product.
9
Please contact 1-855-HD-GLACIER for further assistance.
GG
FF
HOMEDEPOT.COM