Hardware Installation; Configuring The Device - LevelOne WAB-5010 Guía De Instalación Rápida

LED Display
Content

Hardware Installation

Power on the Device.
To power on the AP, you can use one of the following methods:
1. Plug one end of your Ethernet cable into the WAN port of the AP, and the other end into a
port on a PoE switch or a 802.3at PoE injector.
2. Connect the power adapter. (Power adapter unit is to be ordered separately)

Configuring the Device

To set up and manage the AP, you can use one of the following methods:
l Connect the access point and your computer to the same switch or router.Manage the
access point from the computer. (Figure 1)
Software Installation
To login to the LevelOne AP, please perform the following steps:
1. Check Your Network Settings to login web UI.
Please make sure your PC can get IP address automatically, so the router can communicate
with your PC during configuration.
l Select "Control Panel" > "Network Connections".
l Right click the "Local Area Connection" and choose "Properties".
l Select the TCP/IP protocol for your network card.
l Change the IP Address of PC: To configure the IP Address, click the network icon to open
the Ethernet dialog to configure the IP Address. Select "Properties", choose "Internet
Protocol (TCP/IP)" and select "Properties". Input the IP Address "192.168.188.2 ~
192.168.188.250" and continue. (Figure 2)
2. Launch a Web browser (Microsoft Internet Explorer 8 for example), enter the AP's default
LAN IP address 192.168.188.253 in the address bar, and then press Enter, as shown in
the following picture. (Figure 3)
3. Then enter the default user name of admin and password of admin in the User Name and
Password fields, click "OK" to access the AP's Web GUI.
Content Instruction
H: Hotspot, WDS mode,
Master AP 149: Channel is
149
C: Client, WDS Mode, Slave
AP 149: Channel is 149
A: IP Address 253: IP
address is 192.168.188.253
P: RF Power -42: The signal
Strength is -42dBm
Show the channel of AP and
Client; Pls note, the channel
should be same of AP and Client.
If not operate this LED display in
10 mins, the screen will be
automatically black screen
Show AP or Client's IP address;
Remark: In AP and Clients, there
is one device with IP address:
192.168.188.253; Other device
with IP of 192.168.188.X, to avoid
the IP address conflict.
The signal strength is different if
distance different.
-3-
Remark