Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Husqvarna DS50 AT Manual De Instrucciones

Symbols on the machine:

WARNING! The machine can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious or fatal
injury to the operator or others.
Please read the operator's manual carefully
and make sure you understand the
instructions before using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
• Breathing mask
This product is in accordance with
applicable EC directives.
Ensure that water cannot leak into the
machine when drilling in the ceiling.
Use an appropriate water collector
and cover the machine in plastic, but
do not cover the air intakes and air
outlets.
The drilling machine must be suitable and
designed for the size of drill bit, max. drill
diameter is stated on the stand.
The drilling machine must conform to
applicable regulations, EU-requirements
as well as national requirements.
Other symbols/decals on the
machine refer to special certification requirements for
certain markets.
2 –
English

KEY TO SYMBOLS

Symbols in the operator's manual:

Inspection and/or maintenance should
be carried out with the motor switched
off and the plug disconnected.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.